Addition of process elec from H2 not working

[srchlela]

Hello everyone, 

I have an issue with a process that I created (fuel cell) to produce electricity from the H2 in the model. 

The process can be seen in the RES but it writes "no data found for selection" as per the attachments, and theComm in and out are seen in the RES but not attached to this process. 

I've tries starting from scratch and sync but the model still doesn't want to take this process

What could be the problem?

Thank you for your help!

[Antti-L]

Clearly you have a blank column left of the Year column, above which you have the ~FI_T tag, and so the table (or the two parts of the table) is probably getting all ignored due to that blank column.
And assuming you are using VEDA-FE, I think Curr should be to to the left of (or below) the ~FI_T tag column, as it is an index column.

[srchlela]

Clearly you have a blank column left of the Year column, above which you have the ~FI_T tag, and so the table (or the two parts of the table) is probably getting all ignored due to that blank column.
And assuming you are using VEDA-FE, I think Curr should be to to the left of (or below) the ~FI_T tag column, as it is an index column.

Thank you very much!