Problem in setting Max Runs

[vahid.aryanpur]

Hi,
I am writing to report the following issue:

I am using the most updated version of VEDA2.0 and When I should manage the maximum run due to computational limitations, so I set the Max Runs=2. But when I select multiple cases to run and I have different cases with parametric analysis, the VEDA starts to run 2 scenarios per case. Let me explain with the following example: 

I have two cases:
Case 1: including 10 parametric scenarios
Case 2: including 6 parametric scenarios

When I solve these two cases, VEDA starts running 4 scenarios at the same time while I expect to run 2 simultaneously!

I would be grateful if you could guide me on this issue. 

All the best,
Vahid

[dg256]

Hello Vahid,

We have find the solution of this problem. In the next version of Veda this problem will be resolved.

Regards,
Deepak

[vahid.aryanpur]

Hi,
I am writing to report the following issue:

I am using the most updated version of VEDA2.0 and When I should manage the maximum run due to computational limitations, so I set the Max Runs=2. But when I select multiple cases to run and I have different cases with parametric analysis, the VEDA starts to run 2 scenarios per case. Let me explain with the following example: 

I have two cases:
Case 1: including 10 parametric scenarios
Case 2: including 6 parametric scenarios

When I solve these two cases, VEDA starts running 4 scenarios at the same time while I expect to run 2 simultaneously!

I would be grateful if you could guide me on this issue. 

All the best,
Vahid

Thank you very much