A question about trade para defining

[Sharonchang]

I define trade para as shown in demo. But I found that if I define "TU_*" in Pset_PN, the data can be accepted by model. But if I define "TU_GASCRD_REG1_REG2_01", the data can not be found by model. What's the problem with my model? Thanks a lot!

[Vikrant]

Can you post the scenario file?

[Sharonchang]

Ok！This is a very simple defining in my model. Here attached is the tradelink.

[Sharonchang]

Here is the defining of trade para.

[Sharonchang]

If I define para as shown below, it works.

[Sharonchang]

But if I define as below, the data can't be found.

[Vikrant]

What you see in the Times Browse (F7) when you write "TU_*"?

[Sharonchang]

There is only a TU defined in my model so far as shown below

[Vikrant]

Region1 name length is greater than 7, so you can see different process name in the browse.

If you write "TU_GASCRD_injiang_gansu_01" in PSET_PN, it will work.

Due to restrict process name length upto 32, we are generating process name like "TU_" + [Right 10 character of Commodity] + [Right 7 character of Reg1] + [Right 7 character of Reg2].

[Sharonchang]

It does work! Thanks a lot!