Activating NT-PWR not in use in base year

[xavier]

Hello, 

I am modifying my model further. I deleted the refinery sheet since no refinery in the country starting January 2021. I also remained with Industrial demand only. Due to sync problems, I deactivated ForceOplo, NukDel and the Efficiency scenarios. I intended to have Nuclear, Municipal Solid Waste Biomass, Natural Gas and Sub-bitumionous coal considered for futre power generation. I tried to ovverite these in the NT-PWR by a blank but got the attached error after the sync run. If I return them to the inactive state (with the * in column A), the model runs but these technologies are not considered. Attached in the link is the model as well. 

https://www.dropbox.com/home/KENYA-TIMES%20MODEL

Regards,
Xavier

[AKanudia]

https://help.dropbox.com/files-folders/s...ith-others

[xavier]

Hi Amit,

I have send the link> https://www.dropbox.com/sh/16g658lxb4a0p...wf1sa?dl=0 to [email protected] and [email protected]

Regards,
Xavier

[Antti-L]

I am not a VEDA expert, but if you mean the error "The following Commodities have not been defined", I think the message is quite clear:  You need to define those four commodities, in a ~FI_Comm table.

[xavier]

I am not a VEDA expert, but if you mean the error "The following Commodities have not been defined", I think the message is quite clear:  You need to define those four commodities, in a ~FI_Comm table.

Thank You Antti-L for the reply. However, the issue was that once the posted sync error is rectified, the model terminates run midway. But I have since resolved the problem. Thanks.