Veda2.0 Released!


Doubt about output value
#3
(05-10-2021, 06:11 PM)Antti-L Wrote: You are defining NCAP_AFC availability factors for both ELC and NRG flows of the storage. This means that both the ELC output and the NRG inputs will be included in the flow-capacity equations defining the capacity availability.

This is in many cases exactly as desired, because simultaneous charging and discharging is usually not considered typical storage operation, and should in fact be avoided, because such simultaneous flows would basically not require any storage activity (storage level), and would thus not correspond to any genuine storage operation. The combined flow-capacity equations restrict such unusual storage operation, although do not fully prohibit it.

However, for some storage technologies it may be desirable to allow also for simultaneous charging and discharging, and in such cases you may want to consider either 1) leaving the charging flows out of the availability constraint (if bounding the charging by the capacity may be considered unimportant), or 2) defining the availability constraints independently for the output and input flow(s).  The option 1) is  self-explanatory.  The independent option 2) can be enabled by defining NCAP_AFC(r,'0',p,ACT,TSL)= -1; where TSL is the timeslice level, for which you want to have the independent constraints. However, that requires the input / output commodities to be different (always possible by using an aux flow if necessary).

Now I got it! Thank you very much Antii for your explation!!
Reply


Messages In This Thread
Doubt about output value - by DOlih - 05-10-2021, 02:40 PM
RE: Doubt about output value - by Antti-L - 05-10-2021, 06:11 PM
RE: Doubt about output value - by DOlih - 06-10-2021, 06:37 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)